From: Anthony Howe
Date: 2007-05-20 09:00:57 -0400
Subject: milter & libsnert updates...
More information..: http://www.milter.info/#Support
The following updates were released yesterday:
Two VERY notable changes in libsnert that effects the milters,
previously discussed or mentioned here are:
! smfAccessHost(), smfAccessMail(), smfAccessRcpt(): Disabled
support for sendmail's untaggedd access.db entries. These have
been deprecated by sendmail and should no longer be used. This
reduces the access.db lookups for a slight performance gain.
Use --enable-sendmail-tagless-records to enable at compile time.
+ Added smdb-relay-ok option. When enabled, a right hand side
access.db value of RELAY will be treated the same as a white
list OK value, which is technical correct according to the
sendmail definition. However, some sites want to "filter before
relay" and so do not want to treat RELAY as a white list entry.
The first change will mean that untagged sendmail access.db records will
be ignored by DEFAULT, reducing lookups. However if you rely on this
then remember to add the compile time option.
The second change will result in RELAY values being ignored unless
+smdb-relay-ok is set. Some will like this, some will not I'm sure.
The milter-sender update is a critical update to resolve occasional seg.
faults and highly recommended.
Anthony C Howe Skype: SirWumpus SnertSoft
+33 6 11 89 73 78 AIM: SirWumpus Sendmail Milter Solutions
http://www.snert.com/ ICQ: 7116561
Copyright 2009, 2012 by SnertSoft. All rights reserved.